How to Use a Metered-Dose Inhaler (MDI)
- Home
- |
- What is Asthma?
- |
- Asthma Medication and Treatment
- |
- How to Use a Metered...
Using your MDI correctly is essential for getting your full asthma medication dosage
You must inhale the spray quickly enough to prevent it from landing on your tongue or inside your cheek, yet slowly enough to let it get deep into your lungs.
Metered-Dose Inhaler Step-By-Step Instructions:
- Remove the MDI mouthpiece cap and look at the tiny exit hole where the medication comes out of the canister. It should be free of debris or white powder. If it’s not, follow package instructions to thoroughly clean the inhaler.
- Shake the inhaler if necessary, to mix the powder medication with other ingredients inside go through the digestive system and bloodstream, the canister. Check your patient instruction sheet to see if your inhaler requires shaking (and how much), as a few brands (including Alvesco® and QVAR®) are blended differently and don’t need shaking.
- Prime the inhaler if necessary. When the MDI is new or hasn’t been used in a while, the ingredients may separate. Priming ensures the dose you inhale contains the labeled amount of medication. (Note: Priming instructions are different for each MDI brand; check your patient instruction sheet.) When using a valved holding chamber, insert the MDI mouthpiece into the end port of the chamber after priming.
- Stand or sit up straight and breathe out completely. Emptying your lungs as much as possible gives you room to inhale the medication slowly and deeply.
- Hold the inhaler upright with the mouthpiece at the bottom and the top pointing up. Position it as instructed by your physician or the medication’s patient instruction sheet. Some recommend holding the inhaler about 1-2 inches away from your open mouth; others recommend putting the MDI mouthpiece between your teeth and closing your lips tightly around it. Be sure to keep your tongue out of the way of the spray.
- Begin to inhale slowly, then activate the inhaler a split-second later. If you wait too long, you won’t have enough breath left to inhale the medicine deep into your small airways.
- Continue inhaling slowly for 3-5 seconds, until your lungs are full. You might be surprised at how long a time that is, so test yourself. Using a stopwatch device or clock with a second hand, begin to inhale and pretend to actuate your inhaler. See how long it takes you to fill your lungs. Did you run out of room in your lungs before three seconds? If so, try it again, more slowly. Practice until you’re able to get it right. Then practice again … and again.
- Hold your breath for 10 seconds, if possible. (You can take the inhaler out of your mouth.) When you hold your breath, you allow the tiny particles of medication to settle on the surface of your airways.
- Exhale slowly.
- Repeat steps 2 through 9 if your Asthma Action Plan says to take a second dose. (Skip step 3; your inhaler would not need to be primed again so soon.(
- Replace the cap on your inhaler and store it where it won’t be exposed to moisture or extreme temperature changes. Check your patient instruction sheet to see if. Your inhaler needs to be stored in an upright position. For best results, store and use the inhaler at normal room temperature – between 59 and 77 degrees F. In very cold weather, keep it close to your body, not in your car or in a backpack. In cold temperatures, warm the inhaler with your hands before using it.
- Clean the inhaler according to your patient instructions, usually weekly. If using water, leave time for the inhaler to air dry.
English Version
Spanish Version
Quick 3-5 minute videos on asthma, allergies, and related conditions.
How do I monitor my daily asthma symptoms?
National asthma guidelines suggest using a daily symptom diary. This could be Allergy & Asthma Network’s AsthmaTracker™. It helps you keep track of symptoms, peak expiratory flow rates, and medications used.
What is an AsthmaTracker?
The AsthmaTracker™ can help you track how well your symptoms respond to your treatment plan. You write down your symptoms, peak expiratory flow rate and medication use each day. This will help you notice a pattern to your symptoms. With this you can develop strategies to stop the symptoms before they can stop you.
What is a peak flow meter?
A peak flow meter is a handheld device that measures the peak expiratory flow rate (PEFR). This is how much air you can forcibly push out of your lungs at a particular time.
Asthma Storylines – an app for managing asthma
The free Asthma Storylines app is a self-care tool for managing asthma. Track symptoms, learn more about daily patterns and record topics to discuss with your healthcare team.
![Doctor holding up Storylines app on phone Doctor with clipboard in one hand, and a mobile phone in the other, holds up the Asthma Storyline app on his phone to present the app.](https://allergyasthmanetwork.org/wp-content/uploads/2020/05/Doctor-holding-up-Storylines-app-on-phone.jpg)
Are there other conditions that may look like asthma or complicate asthma?
There are other types of respiratory conditions that are different than asthma. The symptoms, diagnosis and treatment can vary depending upon the condition. Here are some of them.